Kia Forte: Interior
| Interior A |
| * These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ] |
| Interior B |
| * These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ] |
| Interior C |
| * These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ] |
| Interior D |
| * These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ] |
|
|
|
|
| Curtain airbag mounting hole (Ø6.6) |
Curtain airbag mounting hole (Ø8.5) |
Cowl crossbar mounting hole (Ø9) |
|
|
|
|
| Front door checker mounting hole (Ø13) |
Cowl side trim mounting hole (Ø8.5) |
Curtain airbag mounting hole (Ø9) |
|
|
|
|
| Seat belt height adjuster upper mounting hole (Ø6.6) |
Seat belt height adjuster lower mounting hole (Ø13) |
Front door striker mounting hole (Ø13) |
|
|
|
|
| Seat belt pretensioner mounting hole
(Ø12.5) |
Curtain airbag mounting hole (Ø6.6) |
Curtain airbag mounting hole (Ø10) |
|
|
|
|
| Rear pillar trim mounting hole (Ø10) |
Rear pillar trim mounting hole (Ø6.6) |
Rear pillar trim mounting hole (7X12) |
|
|
|
|
| Wheel house panel trim mounting hole (Ø8.5) |
Rear package tray panel tooling hole
(Ø6) |
Parking brake lever mounting hole (Ø9) |
|
|
|
|
| Floor wiring harness mounting hole (7X12) |
Front seat mounting hole (Ø13) |
Floor wiring harness mounting hole (7X12) |
|
|
|
|
| Floor wiring harness mounting hole (7X12) |
Rear floor panel tooling hole (7X12) |
Rear seat mounting hole (Ø16.2) |
|
|
|
|
| Rear floor panel tooling hole (8.5X8.5) |
Rear transverse trim mounting hole (Ø8.5) |
Side Body
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
Front side m ...
Rear Body
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
Side outer p ...
See also:
Purge Control Solenoid Valve (PCSV) Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the purge control solenoid valve connector (A) ...
Variable Intake Solenoid (VIS) Valve Description
Variable Intake manifold Solenoid (VIS) valve is installed on the intake
manifold. The VIS valve controls the vacuum modulator which activates a valve
in the intake manifold. The ECM opens or ...
Variable Charge Motion Actuator (VCMA) Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the VCMA connector (A).
...