Kia Forte: Side Body
| * These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ] |
|
|
|
|
| Front side member tooling hole (Ø12) |
Fender apron upper member tooling hole (Ø9) |
Front door upper hinge mounting hole
(Ø13) |
|
|
|
|
| Front door lower hinge mounting hole
(Ø13) |
Side outer panel notch |
Side outer panel notch |
|
|
|
|
| Side outer panel notch |
Side outer panel notch |
Front door switch mounting hole (Ø10) |
|
|
|
|
| Rear door upper hinge mounting hole (Ø13) |
Rear door lower hinge mounting hole (Ø13) |
Side outer panel notch |
|
|
|
|
| Side outer panel notch |
Side outer panel notch |
Rear door switch mounting hole (Ø10) |
|
|
|
|
| Side outer panel rear corner |
Rear bumper mounting hole (Ø12) |
Front Body
Front Body A
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
Front Body B
* These dimensions indicated in th ...
Interior
Interior A
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
Interior B
* These dimens ...
See also:
Removal
Pressure Side Impact Sensor
•
Removal of the airbag must be performed according to ...
Power Mosfet Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Disconnect the power mosfet connector (A) and then remove the
power mosfet (B) after lo ...
Inspection
If any of the following conditions occur, WCS reset and accuracy check
should be performed.
•
The WCS ECU or any of the sensors is replaced.
•
...
Copyright © www.kifomanual.com 2014-2024