Kia Forte: Speakers Inspection - Audio - Body Electrical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Speakers Inspection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Audio / Speakers Inspection

1.
Troubleshooting for Speaker
(1)
Basic inspection of speaker
Inspect the sound from speaker after verifying that the speaker mounting screws are removed and the wiring connector is connected to remove any possible vibration transmitted from body trims and surrounding parts.

(2)
Case Troubleshooting
No.
Case
Inspection/Remedy
1
Trembling sound
1.
Before replacing the speaker, inspect that the mounting screw is installed normally.
2.
After re-installing the speaker, verify that no trembling sound is heard.
3.
When hearing a trembling sound again, replace the speaker with new one.
2
Noise
1.
Check if the wiring connector is connected normally. If not, reconnect the wiring connector.
2.
In case of radio static, check if there is a noise from CD.
3.
If a noise is heard with the radio and CD on, replace the speaker with new one.
  
In case there is only radio static, this may be the cause of the poor radio reception. Thus the speaker needs no repair and replacement.
3
Speaker
in operative
Inspection of the wiring connection between the battery and the speaker
1.
Before replacing the speaker, inspect the wiring connection between the battery and the speaker is normal.
2.
Check the supply power to the speaker and the resistance, then inspect the sound quality.

3.
If the speaker works poorly, replace it with new one.

  
When handling the speaker :
-
Dropping or rough handling of the speaker can cause damage.
-
Be careful not to spill water or oil on the speaker.
-
Caution when dealing with speaker because the diaphragm is paper and can be easily torn by impact and external force.
-
Electrical mishandling of speakers is not cevered by manufacturers warranty.
Audio Unit Installation
1. Connect the audio unit connectors and cables. 2. Install the audio unit. 3. Install the center fascia panel ...

Speakers Removal
Front Speaker 1. Remove the front door trim panel and speaker connector. (Refer to Body - "Front Door Trim") 2. Remove the ...

See also:

Inspection
Lighting Switch Inspection With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the mul ...

Roof Trim Assembly Replacement
   • Put on gloves to protect your hands. &n ...

Back up lamp, Rear fog lamp
1. Take the lamp assembly out. 2. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly. 3. Remove the bulb by ...

Copyright © www.kifomanual.com 2014-2024