Kia Optima Manuals

Kia Forte: Starter Removal - ISG (Idle Stop & Go) System - Engine Control / Fuel System - Kia Forte TD 2014-2018 Service ManualKia Forte: Starter Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / Starter Removal

1.
Disconnect the battery negative (-) cable.
2.
Remove the air duct and air cleaner assembly.
(Refer to Engine Mechanical System - "Engine And Transaxle Assembly")
3.
Disconnect the starter cable (A) from the B terminal on the solenoid then disconnect the connector (B) from the S terminal.
Tighting torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

4.
Remove the 2 bolts holding the starter, then remove the starter (A).
Tighting torque :
49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)

Starter Description
The starting system includes the battery, starter, solenoid switch, inhibitor switch (A/T), ignition switch, ignition lock switch, connection wires and the battery cable. When the ignitio ...

Starter Installation
1. Install in the reverse of removal. ...

See also:

General
1. Basically, all measurements in this manual are taken with a tracking gauge. 2. When a measuring tape is used, check to be sure there is ...

Light bulbs
WARNING - Lights Prior to working on the light, firmly apply the parking brake, ensure that the ignition switch is turned to the “LOCK”position and turn off the lights to avoid burning your fin ...

On-vehicle Inpection
   • First of all, check for DTCs. If a DTC is present, perform troubleshooting in accord ...

Categories

Copyright www.kifomanual.com 2014-2026