Kia Forte: TJ Joint Components - Driveshaft Assembly - Driveshaft and axle - Kia Forte TD 2014-2018 Service ManualKia Forte: TJ Joint Components

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Driveshaft and axle / Driveshaft Assembly / TJ Joint Components

[LH]

1. BJ assembly
2. BJ circlip
3. BJ boot band
4. BJ boot
5. Shaft
6. TJ boot band
7. TJ boot
8. Spider assembly
9. Snap ring
10. TJ case
11. Snap ring

[RH]

1. BJ assembly
2. Circlip
3. BJ boot band
4. BJ boot
5. Dynamic damper band
6. Dynamic damper
7. Shaft
8. TJ boot band
9. TJ boot
10. Spider assembly
11. Snap ring
12. TJ case
13. Circlip

Front Driveshaft Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A ...

TJ Joint Replacement
   • Special grease must be applied to the driveshaft joint. Do not substitute with another ...

See also:

Installation
1. Install the multifunction switch. 2. Install the clock spring. 3. Install the steering column upper and lowe ...

Starter Specification
Starter [Non-ISG type] Item Specification Rated voltage 12 V, 1.2 kW The number of pinion teeth 13 Performance [No-load, 11 V] ...

Variable Charge Motion Actuator (VCMA) Description
The Variable Charge Motion Actuator (VCMA) is installed on the inlet of the intake manifold. It consists of a DC motor which actuates the VCM valve and a position sensor which detects th ...

Copyright © www.kifomanual.com 2014-2024