Kia Forte: Under Body
| Projected Dimensions |
| * These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ] |
| Actual-Measurement Dimensions |
| * These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ] |
|
|
|
|
| Front side member tooling hole (Ø25) |
Side cover mounting hole (Ø8.6) |
Side cover mounting hole (Ø10.7) |
|
|
|
|
| Sub frame mounting bolt |
Sub frame mounting hole (Ø11) |
Center floor tooling hole (Ø8) |
|
|
|
|
| Front side member tooling hole (Ø13) |
Center floor side member tooling hole
(Ø7) |
Rear floor side member tooling hole (Ø10) |
|
|
|
|
| Rear floor side member tooling hole (Ø10) |
Rear floor side member tooling hole (Ø10) |
Rear floor center cross member tooling hole (Ø10) |
|
|
|
|
| Rear floor center cross member tooling hole (Ø10) |
Rear spring mounting hole (Ø9) |
Rear floor side member tooling hole (Ø8) |
|
|
||
| Rear floor side member tooling hole (Ø8) |
Rear Body
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
Side outer p ...
Front Cross Member
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
...
See also:
Transaxle Control Module (TCM) Replacement
1.
Turn ignition switch OFF.
2.
Disconnect the negative (-) battery cable.
3.
Disconnect the TCM connector (A ...
Operation
1.
General Function
A.
Auto-learn takes place only once per Ignition cycle.
B.
On successful compl ...
Camshaft Position Sensor (CMPS) Removal
•
DON’T remove the camshaft position sensor during engine
running or right after engine ...
Copyright © www.kifomanual.com 2014-2025