Kia Forte: Water pump Troubleshooting - Cooling System - Engine Mechanical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Water pump Troubleshooting

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Mechanical System / Cooling System / Water pump Troubleshooting

Symptoms
Possible Causes
Remedy
Coolant leakage
From the bleed hole of the water pump
Visually check
Check leaks after about ten-minute warming up.
If coolant still leaks, replace a water pump.
If leakage stops, reuse the water pump (Do not replace the pump with a new one).
From gaskets or bolts
Check the tightening of the water pump mounting bolts.
Retighten the mounting bolts.
Check damage of gaskets or inflow of dust.
Replace the gasket and clean dust off.
From outer surface of water pump
Check the material or any cracks of the water pump.
Poor material. If any crack found, replace the water pump.
Noise
From bearings
From mechanical seals
Impeller interference
Inspection with a stethoscope
After starting the engine, check noise with a stethoscope.
If there is no noise, reuse the water pump (do not replace it).
If there is any noise from the water pump, remove the drive belt and recheck.
Inspection after removing a drive belt
After removing a water pump and a drive belt, check noise again.
If there is noise, reuse the water pump. Check other drive line parts.
If there is no noise, replace the water pump with a new one.
Inspection after removing a water pump
After removing a water pump and a drive belt, check noise again.
If there is any interference between them, replace the water pump with a new one.
Overheating
Damaged impeller
Loosened impeller
Loosened impeller
Corrosion of the impeller wing
Check engine coolant.
Poor coolant quality / Maintenance check
Impeller seperation from the shaft
Replace the water pump.

Water pump Inspection
1. Check each part for cracks, damage or wear, and replace the coolant pump assembly if necessary. 2. Check the bearing for damage, abnorm ...

Thermostat Components
1. Water inlet fitting 2. Thermostat 3. Bypass hose 4. Heater pipe & hose assembly ...

See also:

BJ Boot Components
1. BJ assembly 2. Circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band 9. TJ boot 10. Spider assembly 1 ...

Operation
1. Vehicle moving. 2. The transmission lever position is D-range. The brake pedal is released. 3. The ...

Explanation of scheduled maintenance items
Engine oil and filter The engine oil and filter should be changed at the intervals specified in the maintenance schedule. If the car is being driven in severe conditions, more frequent oil and filt ...

Copyright © www.kifomanual.com 2014-2024