Kia Forte: Wipers & Washers

A : Wiper speed control (front)
B : Intermittent control wipe time adjustment
C :Wash with brief wipes (front)
D : Rear wiper/washer control
E :Wash with brief wipes (rear)
Windshield wipers
Operates as follows when the ignition switch is turned ON.
MIST :
For a single wiping cycle, push the lever upward and release it. The wipers will operate continuously if the lever is held in this position.
OFF :
Wiper is not in operation
INT :
Wiper operates intermittently at the same wiping intervals. Use this mode in a light rain or mist. To vary the speed setting, turn the speed control knob.
LO :
Normal wiper speed
HI :
Fast wiper speed
If there is a heavy accumulation of snow or ice on the windshield, defrost the windshield for about 10 minutes, or until the snow and/or ice is removed before using the windshield wipers to ensure proper operation.
Turn signals and lane change signals
Windshield washers (front)Dynamic Damper Components
1. BJ assembly
2. Circlip
3. BJ boot band
4. BJ boot
5. Dynamic damper band
6. Dynamic damper
7. Shaft
8. TJ boot band
9. TJ boot
10. Spider assembly
1 ...
Oil Pump Unit (OPU) Removal
1.
Remove the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - “Crash Pad”)
...
Auto Light Sensor Inspection
In the state of IGN1 ON, when multifunction switch module detects auto
light switch on, tail lamp relay output and head lamp low relay output are controlled
according to auto light sensor' ...