Kia Forte: Interior
| Interior A |
| * These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ] |
| Interior B |
| * These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ] |
| Interior C |
| * These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ] |
| Interior D |
| * These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ] |
|
|
|
|
| Curtain airbag mounting hole (Ø6.6) |
Curtain airbag mounting hole (Ø6.6) |
Curtain airbag mounting hole (Ø6.6) |
|
|
|
|
| Curtain airbag mounting hole (Ø6.6) |
Cowl crossbar mounting hole (Ø9) |
Front door checker mounting hole (Ø13) |
|
|
|
|
| Cowl side trim mounting hole (Ø8.5) |
Curtain airbag mounting hole (Ø6.6) |
Seat belt height adjuster upper mounting hole (Ø16) |
|
|
|
|
| Seat belt height adjuster lower mounting hole (Ø16) |
Rear door checker mounting hole (Ø13) |
Seat belt pretensioner mounting hole
(Ø12.5) |
|
|
|
|
| Curtain airbag mounting hole (Ø6.6) |
Curtain airbag mounting hole (Ø6.6) |
Quarter inner panel tooling hole (Ø6) |
|
|
|
|
| Quarter inner panel tooling hole (Ø6) |
Rear door striker mounting hole (Ø13) |
Wheel house panel mounting hole (Ø8) |
|
|
|
|
| Quarter inner panel tooling hole (Ø8.5) |
Luggage side trim mounting hole (Ø6)
|
Luggage side trim mounting hole (Ø6) |
|
|
|
|
| Parking brake lever mounting hole (Ø9) |
Floor wiring harness mounting hole (12X7) |
Front seat mounting hole (Ø13) |
|
|
|
|
| Floor wiring harness mounting hole (12X7) |
Floor wiring harness mounting hole (12X7) |
Rear floor panel tooling hole (12X7) |
|
|
|
|
| Rear seat mounting hole (Ø16) |
Rear floor panel tooling hole (Ø10) |
Rear transverse trim mounting hole (Ø8.5) |
Side Body
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
Front side m ...
Rear Body
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
Side outer p ...
See also:
Starter Inspection
Starter Solenoid Inspection
1.
Disconnect the lead wire from the M-terminal of solenoid switch.
2.
Connect the battery as shown. If ...
Rear Glass Defogger Switch Replacement
1.
Remove the center fascia panel.
(Refer to Body - "Center Fascia Panel")
2.
Remove the cluster fascia panel.
(Refer ...
Checking the washer fluid level
Check the fluid level in the washer fluid reservoir and add fluid if necessary.
Plain water may be used if washer fluid is not available.
However, use washer solvent with antifreeze characterist ...