Kia Forte: Start/Stop Button Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Button Engine Start System / Start/Stop Button Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Using a screwdriver or remover, remove the center garnish [LH]
(A).
|
| 3. |
Using a screwdriver or remover, remove the cluster fascia panel
(A).
|
| 4. |
Remove the start/stop button (A) after loosening the screws from
the cluster fascia panel.
|
Start/Stop Button Installation
1.
Install the start/stop button.
2.
Connect the start/stop button connector.
3.
Install the cluster fascia pan ...
See also:
Front Hub / Knuckle Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A ...
On-board Refueling Vapor Recovery (ORVR) valve Removal
1.
Turn the ignition switch OFF, and then remove battery (-) cable.
2.
Remove the fuel pump.
(Refer to Fuel System - "Fuel Pump&qu ...
Copyright © www.kifomanual.com 2014-2024