Kia Forte: Temperature Control Actuator Replacement
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Heating,Ventilation, Air Conditioning / Heater / Temperature Control Actuator Replacement
| [Driver's side] |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the crash pad lower panel.
(Refer to Body -"Crash Pad Lower Panel")
|
| 3. |
Remove the driver's side shower duct by loosening the screw.
|
| 4. |
Disconnect the connector (A) and then remove the temperature control
actuator (B) after loosening the mounting screws.
|
| 5. |
Install in the reverse order of removal.
|
| [Passenger's side] |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the glove box housing.
(Refer to Body -"Glove Box Housing")
|
| 3. |
Remove the passenger's side shower duct by loosening the screw.
|
| 4. |
Disconnect the connector (A) and then remove the temperature control
actuator (B) after loosening the mounting screws.
|
| 5. |
Install in the reverse order of removal.
|
Temperature Control Actuator Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the temperature control actuator connector.
3.
Verify that the t ...
Mode Control Actuator Description
The mode control actuator is located at the heater unit.
It adjusts the position of the mode door by operating the mode control
actuator based on the signal of the A/C control unit. Pressing ...
See also:
ECM Terminal And Input/Output signal (A/T)
ECM Terminal Function
Connector [CNG-AA]
Pin No.
Description
Connected to
1
Ignition Coil (Cylinder #2) control output
Ignition Co ...
Rear Door Latch Component Location
(4Door, 5Door)
1. Rear door latch
...
Rear Drum Brake
Components
1. Shoe hold down pin
2. Shoe adjuster
3. Upper return spring
4. Adjusting lever
5. Shoe
6. Adjusting spring
7. Lower return spring
8. Shoe hold spri ...
Copyright © www.kifomanual.com 2014-2025