Kia Forte: AGM Battery Specification - ISG (Idle Stop & Go) System - Engine Control / Fuel System - Kia Forte TD 2014-2018 Service ManualKia Forte: AGM Battery Specification

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / AGM Battery Specification

Item
Specification
Model type
AGM 70L-DIN
Capa ticy [20HR / 5HR] (AH)
70/56
Cold Cranking Amperage (A)
760 (SAE) / 610 (EN)
Reserve capacity (Min)
120

  

Cold Cranking Ampere (CCA): Cold Cranking Amps is a rating used in the battery industry to define a battery's ability to start an engine in cold temperatures.
-
The rating is the number of amps a new, fully charged battery can deliver at -18 °C(-0.4 °F) for 30 seconds, while maintaining a voltage of at least 7.2 volts for a 12 volt battery.
-
The higher the CCA rating, the greater the starting power of the battery.
RESERVE CAPACITY (RC) : Reserve Capacity is a battery industry rating, defining a battery's ability to power a vehicle with an inoperative alternator or fan belt.
-
The rating is the number of minutes a battery at 26.7 °C(80 °F) can be discharged at 25 amps and maintain a voltage of 10.5 volts for a 12 volt battery.
-
The higher the reserve rating, the longer your vehicle can operate should your alternator or fan belt fail.

AGM Battery Description
AGM battery is used for especially heavy load on the vehicle network depending on equipment and requirements. AGM stands for Absorbent Glass Material Battery; that is absorbent glass fibre fl ...

AGM Battery Adjustment
Battery charging In general, vehicle battery charging system has three forms. 1. Constant current charge: The battery voltage gradually rises by charging w ...

See also:

Component
1. Concentric slave cylinder assembly 2. Manual transaxle ...

Components Location
1. Purge Control Solenoid Valve (PCSV) 2. Vapor line 3. ORVR valve 4. Fuel tank air filter 5. Canister Close Valve (CCV) 6. Canister 7. Fuel Tank Pressure Sensor ( ...

Installation
1. Install in the reverse order of removal. 2. Tighten the vacuum pump mounting bolts to the specified torque. ...

Copyright © www.kifomanual.com 2014-2024