1. |
Remove the fuel pump (Refer to “Fuel Pump” in this group).
|
2. |
Disconnect the electric pump wiring connector (A) and the fuel
sender connector (B).
|
3. |
Remove the head assembly (A) after releasing the cushion fixing
clip (B).
|
4. |
Disconnect the fuel tube quick-connectors (C).
|
5. |
Remove the fuel sender (A) in the direction of an arrow.
|
6. |
Disconnect the fuel tube connector (A).
|
7. |
Remove the cut valve (A) after releasing hooks (B).
|
8. |
Remove the reservior-cup (B) after releasing the fixing hooks
(A).
|
9. |
Release the fixing hooks, and then remove the pre-filter (A) and
the fuel pressure regulator (B).
1. Head Assembly
2. Electric Pump Motor
3. Fuel Filter
4. Fuel Sender
5. Fuel Pressure Regulator
6. Pre-filter
7. Reservoir cup
|
IMS Control Switch Inspection
1.
With the power seat switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified,
replace the power seat ...
CVVT & Camshaft Inspection
Camshaft
1.
Inspect the cam lobes.
Using a micrometer, measure the cam lobe height.
If the cam lobe height is less than specification, replace the
camsh ...
Cylinder Head Components
1. Camshaft bearing cap
2. Camshaft front bearing cap
3. Exhaust camshaft
4. Intake camshaft
5. Exhaust CVVT assembly
6. Intake CVVT assembly
7. Cam carrier
8. Cyli ...