Kia Forte: Filler-Neck Assembly Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Filler-Neck Assembly Removal
| 1. |
Open the fuel filler door and unfasten the filler-neck assembly
mounting screw (A).
|
| 2. |
Remove the rear-LH wheel, tire, and the inner wheel house.
|
| 3. |
Disconnect the fuel filter hose (A) and the ventilation hose (B).
|
| 4. |
Remove the filler-neck assembly from the vehicle after removing
the bracket mounting bolts (C).
|
Fuel Line Installation
•
Install the component with the specified torques.
•
...
Filler-Neck Assembly Installation
1.
Install in the reverse order of removal.
Filler-neck assembly bracket
installation bolt :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ...
See also:
Wipers & Washers
A : Wiper speed control (front)
· HI – High wiper speed
· LO – Low wiper speed
· INT – Intermittent wipe
· AUTO– Automatic control wipe
· OFF – Off
· MIST – Single wipe
B : Interm ...
Removal
1.
Separate the push rod (C) after remove the pin (A) and washer
(B).
2.
Remove the battery.
(Refer to Engine Electrical S ...
Crankshaft Inspection
1.
Check the crankshaft bearing oil clearance.
(1)
To check main bearing-to-journal oil clearance, remove
the lower crankcase and lo ...
Copyright © www.kifomanual.com 2014-2025