Kia Forte: Underdrive Brake Control Solenoid Valve(UD/B_VFS) Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Underdrive Brake Control Solenoid Valve(UD/B_VFS) Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the hydraulic pressure
will need to be adjusted after replacing the VFS solenoid valve. If
replacing the VFS solenoid valve; also replace the valve body assembly.
(Refer to "Valve Body" in this group)
|
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the Solenoid valve connector.
3.
Measure resistance between sensor ...
Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Description
Overdrive Clutch(OD/C) Control Solenoid Valve is attached to the valve
body. This variable force solenoid valve directly controls the hydraulic pressure
inside the Overdrive Clutch(OD/C)
...
See also:
Specification
Smart Key Unit
Items
Specification
Rated voltage
DC 12V
Operating voltage
DC 9 ~ 16V
Operating temperature
-30°C ~ 75°C (- ...
Parking Brake Lever Installation
1.
Install the parking brake lever assembly (A).
Tightening torque :
19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m, 14.5 ~ 21.7 lb-ft)
...
Power Seat Control Switch Inspection
1.
With the power seat switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified,
replace the power seat ...
Copyright © www.kifomanual.com 2014-2025