Kia Forte: Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Clutch System / Clutch Release Fork and Clutch Release Bearing / Installation

1.	Install the boot (A).

2.	Install the clip to the clutch release fork.

3.

Apply to grease in location A, B and C.

Location	Quantity (g)	Remarks
A	0.3 ~ 0.5	Release bearing & Fork
B	0.5 ~ 1.0	Release Fork & Fulcrum
C	0.4 ~ 0.8	Release cylinder & Fork

4.

Apply the grease to the hole surface of the clutch release bearing all around.

Specified grease : CASMOLY L9508

Amount : 0.5 ~ 1.0 g

5.	Install the clutch release fork (B), clutch release bearing (A).

6.	Install the transaxle assembly. (Refer to Manual Transaxle System - " Manual Transaxle")

Inspection

1. Check for damage to boot. 2. Check for deformation to clutch release fork. 3. Check for deformation to clutc ...

Concentric Slave Cylinder Assembly

...

See also:

ECM Problem Inspection Procedure
1. TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis ground using the backside of ECM harness connector as ECM side check point. If the problem is fo ...

Head Lamp Leveling Actuator Inspection with GDS
Initialization and diagnosis sequence by using GDS equipment. Below content summarize the procedure for A/S using GDS. No. Procedure 1 Locate vehicle to flat ...

Installation
• If the oil seal on the transaxle case side is damaged and fluid is leaking, replace ...

Categories

Copyright � www.kifomanual.com 2014-2026