1. |
Disconnect the battery negative cable, and wait for at least thirty
seconds before beginning work.
|
2. |
Remove the seat belt after pushing the lock pin (A).
|
3. |
Remove the door scuff trim.
(Refer to Body - "Door scuff trim")
|
4. |
Remove the center pillar trim.
(Refer to Body - "Center pillar trim")
|
5. |
Disconnect the emergency fastening device connector (A).
|
6. |
Loosen the emergency fastening device mounting bolt (B) and remove
the emergency fastening device.
|
Brake Booster Vacuum Pressure Sensor Inspection
1.
Check installation status of BBVPS and Vacuum hose or damage of
vacuum hose.
2.
Connect GDS to DLC (Data Link Cable).
...
Emergency Fastening Device (EFD)
Front emergency fastening device operates as well as belt pretensioner
at the same time If it gets into its deploy condition after a collision. It
is located at near anchor on front seat and ...
Front Wheel Speed Sensor Removal
1.
Remove the front wheel and tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
...