Never attempt to measure the circuit resistance of the Emergency
Fastening Device (EFD) even if you are using the specified tester. If
the circuit resistance is measured with a tester, the pretensioner will
be ignited accidentally. This will result in serious personal injury.
|
Drive Belt Tensioner Removal and Installation
1.
Remove the drive belt.
(Refer to Timing System - "Drive Belt")
2.
Remove the alternator lower bolt (A).
...
Rear Door Belt Inside Weatherstrip Replacement
(4Door, 5Door)
1.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
2.
Remove the rear door bel ...
Heater Unit Components
1. Heater Case (Left)
2. Heater Case (Right)
3. Console Separator
4. Defog Door
5. Vent Door
6. Floor Door
7. Mix Door (Manual)
8. Mix Door (DATC-Left)
9. Mix Door ( ...