1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
|
3. |
Remove the driver side shower duct after loosening the screw.
|
4. |
Disconnect the PTC heater connector (A).
|
5. |
Remove the PTC heater core (A) after loosening the PTC heater
mounting screws.
|
6. |
Install in the reverse order of removal.
|
Installation
1.
Install the BCM unit.
2.
Install the center lower cover.
3.
Install the floor console assembly.
...
Troubleshooting
Ignition System
Symptom
Suspect Area
Remedy
Engine will not start or is hard to
start (Cranks OK)
Ignition lock switch
Inspect ignitio ...
Rear Coil Spring Inspection
1.
Check the coil spring for crack and deformation.
2.
Check the coil spring pad for damage and deformation.
...