Kia Forte: Rear Door Latch Replacement - Rear Door - Body (Interior and Exterior) - Kia Forte TD 2014-2018 Service ManualKia Forte: Rear Door Latch Replacement

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Latch Replacement

(4Door, 5Door)
1.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
2.
Remove the rear door rear seal (A).

3.
Loosen the rear door latch (A) mounting screws.

Tightening torque:
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

4.
Disconnect the rear door latch connector (A).

5.
Remove the rear door outside handle rod (A).

6.
Remove the rear door latch assembly (A).

7.
Install in the reverse order of removal.
  
Make sure the connector is connected properly.
Make sure the door locks/unlocks and opens/closes properly.
Replace any damaged clips.
Ensure that the the cage and inside handle is assembled.
Rear Door Latch Component Location
(4Door, 5Door) 1. Rear door latch ...

Rear Door Belt Outside Weatherstrip Replacement
(4Door, 5Door) 1. Pull down rear door window glass by pressing the power window glass switch. 2. After loosening the mounting ...

See also:

TJ Joint Components
[LH] 1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Shaft 6. TJ boot band 7. TJ boot 8. Spider assembly 9. Snap ring 10. TJ c ...

Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least thirty seconds. ...

Schematic Diagram
Canister The Canister is filled with charcoal and absorbs evaporated fuel vapor from the fuel tank. The gathered fuel vapor in canister is drawn into the intake manifold by the ECM/PC ...

Copyright © www.kifomanual.com 2014-2025