(4Door, 5Door) |
|
|
1. |
Using a screwdriver or remover, remove the rear door inside handle
cap (A).
|
2. |
Remove the rear door pull handle cap (B).
|
3. |
After loosening the mounting screws, then remove the rear door
trim (A).
|
4. |
Remove the rear door inside handle cage (A).
|
5. |
Disconnect the power window switch connector (A).
|
6. |
Install in the reverse order of removal.
|
Troubleshooting
Trouble Symptom
Probable cause
Remedy
Vehicle pulls to one side
Scoring of driveshaft ball joint
Replace
Wear, rattle or scoring of wheel b ...
Roof Trim Assembly Replacement
•
Put on gloves to protect your hands.
&n ...
Heated Oxygen Sensor (HO2S) Removal
[SULEV]
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the connector (A), and th ...