Kia Forte: Starter Installation - Starting System - Engine Electrical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Starter Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Electrical System / Starting System / Starter Installation

1.
Install in the reverse order of removal.

Starter installation bolt: 49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)

Starter Removal
1. Disconnect the battery negative terminal. 2. Remove the air duct and air cleaner assembly. (Refer to Engine Mechanical System - &quo ...

Starter Disassembly (NON-ISG Type)
1. Disconnect the M-terminal (A) on the magnet switch assembly. 2. After loosening the screws (A), detach the magnet switch ssembly ...

See also:

Front Impact Sensor (FIS)
The front impact sensor (FIS) is installed in the front side member. They are remote sensors that detect acceleration due to a collision at its mounting location. The primary purpose of the F ...

Automatic climate control system
...

ECM Problem Inspection Procedure
1. TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis ground using the backside of ECM harness connector as ECM side check point. If the problem is fo ...

Copyright www.kifomanual.com 2014-2026