Kia Forte: Starter Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Electrical System / Starting System / Starter Removal
| 1. |
Disconnect the battery negative terminal.
|
| 2. |
Remove the air duct and air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
|
| 3. |
Disconnect the starter cable (A) from the B terminal on the solenoid
then disconnect the connector from the S terminal (B).
|
| 4. |
Remove the 2 bolts holding the starter, then remove the starter
(A).
|
Starter Installation
1.
Install in the reverse order of removal.
Starter installation bolt:
49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)
...
See also:
Inspection
Front Door Lock Module Inspection
1.
Remove the front door trim.
(Refer to Body - "Front Door Trim")
2.
Remove the front d ...
Drive Belt Tensioner Inspection
Check the belt tensioner for excessive foreign substances, crack, damage
or sticking of pivot shaft. Replace if necessary. ...
Crankshaft Position Sensor (CKPS) Inspection
1.
Check signal waveform of CKPS and CMPS using a scan tool.
Specification:
Refer to “Waveform”
...
Copyright © www.kifomanual.com 2014-2025