Kia Forte: Starter Reassembly

Starter Disassembly (NON-ISG Type)

1. Disconnect the M-terminal (A) on the magnet switch assembly. 2. After loosening the screws (A), detach the magnet switch ssembly ...

Starter Inspection

Starter Solenoid Inspection 1. Disconnect the lead wire from the M-terminal of solenoid switch. 2. Connect the battery as shown. If ...

See also:

Removal
1. Drain the brake fluid through the bleed plug (A).    • ...

Ignition Coil Installation
1. Install in the reverse order of removal. Ignition coil installation bolts: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 Ib-ft) ...

ECM Problem Inspection Procedure
1. TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis ground using the backside of ECM harness connector as ECM side check point. If the problem is fo ...