Kia Optima Manuals

Kia Forte: Transaxle Control Module (TCM) Installation - Automatic Transaxle Control System - Automatic Transaxle System - Kia Forte TD 2014-2018 Service ManualKia Forte: Transaxle Control Module (TCM) Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Transaxle Control Module (TCM) Installation

1.
Installation is reverse of removal.
  
•
In the case of the vehicle equipped with immobilizer or button engine start system, perform "Key Teaching" procedure together (Refer to "Immobilizer" or "Button Engine Start System in BE group).
•
Perform TCM learning after replacing the transaxle to prevent slow transaxle response, jerky acceleration and jerky startup.
(Refer to Automatic Transaxle Control System - "Repair procedures")
Transaxle Control Module (TCM) Replacement
1. Turn ignition switch OFF. 2. Disconnect the negative (-) battery cable. 3. Disconnect the TCM connector (A ...

Transaxle Oil Temperature Sensor Description
Transaxle Oil Temperature Sensor(OTS) monitors the automatic transaxle fluid's temperature and conveys the readings to Transaxle Control Module(TCM). It is an Negativen Thermal Coefficien ...

See also:

Compressor Description
The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low pressure and low temperatur ...

Parking Assist System Switch Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the floor console assembly. (Refer to Body - "Floor Console Assembly&quo ...

Circuit Diagram
Hamess Connector Pin No. Discription Remark 1 - 2 - 3 - 4 ...

Categories


Copyright © www.kifomanual.com 2014-2025