Kia Forte: Transaxle Control Module (TCM) Replacement - Automatic Transaxle Control System - Automatic Transaxle System - Kia Forte TD 2014-2018 Service ManualKia Forte: Transaxle Control Module (TCM) Replacement

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Transaxle Control Module (TCM) Replacement

1.
Turn ignition switch OFF.
2.
Disconnect the negative (-) battery cable.
3.
Disconnect the TCM connector (A).

4.
Remove the TCM (A) after removing the bolt and nut.

TCM installation bolt/nut:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Transaxle Control Module (TCM) Inspection
Transaxle Control Module(TCM) Problem Inspection Procedure 1. TEST TCM GROUND CIRCUIT: Measure resistance between TCM and chassis ground using the backside of TCM harne ...

Transaxle Control Module (TCM) Installation
1. Installation is reverse of removal.    • ...

See also:

Blower Unit Components
1. Intake Seal 2. Intake Upper Case 3. Intake Actuator 4. Air Filter 5. Air Filter Cover 6. Intake Door Assembly 7. Intake Lower Case 8. NVH Pad 9. Blower Up ...

High Mounted Stop Lamp Installation
[2 Door] 1. Install the high mounted stop lamp assembly. 2. Install the roof trim assembly. [4 Door] 1. ...

Room Lamp Removal
Room Lamp 1. Disconnect the negative(-) battery terminal. 2. Carefully remove the lamp lens (A) from the room lamp with a flat-tip scre ...

Copyright © www.kifomanual.com 2014-2025