Kia Forte: Variable Intake Solenoid(VIS) Actuator Removal and Installation
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Mechanical System / Intake And Exhaust System / Variable Intake Solenoid(VIS) Actuator Removal and Installation
| 1. |
Disconnect the vacuum hose (A).
|
| 2. |
Remove the variable Intake solenoid (VIS) actuator (B)
|
| 3. |
Install in the reverse order of removal.
|
Intake Manifold Removal and Installation
1.
Remove the engine cover.
2.
Disconnect the battery negative terminal.
3.
Disconnect the wiring connectors a ...
Exhaust Manifold Components
1. Heat protector
2. Exhaust manifold gasket
3. Exhaust manifold
4. Exhaust manifold stay
...
See also:
Delivery Pipe Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Release the residual pressure in fuel line (Refer to the ...
Limp Home Function
1.
Limp Home By Tester
If the ECM detects the fault of the Immobilizer or transponder,
the ECM will allow limp home function of the immobilizer. Limp home
is o ...
SS-A Solenoid Valve(ON/OFF) Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the Solenoid valve connector.
3.
Measure resistance between sensor ...
Copyright © www.kifomanual.com 2014-2025