Kia Forte: Drive Belt Tensioner Removal and Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Mechanical System / Timing System / Drive Belt Tensioner Removal and Installation

1.	Remove the drive belt. (Refer to Timing System - "Drive Belt")

2.	Remove the alternator lower bolt (A).

3.

Remove the alternator brace (B).

Tightening torque :

21.6 ~ 32.4 N.m (2.2 ~ 3.3 kgf.m, 15.9 ~ 23.9 lb-ft)

4.	Install in the reverse order of removal.

Drive Belt Tensioner Components

1. Alternator brace 2. Adjust nut ...

Drive Belt Tensioner Inspection

Check the belt tensioner for excessive foreign substances, crack, damage or sticking of pivot shaft. Replace if necessary. ...

See also:

Inspection
Check it by the procedure below to see if the function of the ECM is normal. 1. Turn the ignition key to the "ON" position. 2. Cov ...

Compressor Description
The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low pressure and low temperatur ...

Engine Coolant Temperature Sensor (ECTS) Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the engine coolant temperature sensor connecto ...

Categories

Copyright © www.kifomanual.com 2014-2026