Kia Forte: Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Low Panal")
|
| 3. |
Remove the steering column upper and lower shrouds.
(Refer to Body - "Steering Column Shroud Panel")
|
| 4. |
Remove the wiper switch.
(Refer to "Multifunction switch")
|
| 5. |
Remove the ignition switch after disconnecting the ignition switch
6P connector.
|
| 6. |
Remove the key warning/immobilizer connector (A).
|
| 7. |
After loosening the screw, remove the key warning switch and key
Illumination (B).
|
| 8. |
Pushing lock pin with key ACC.
|
| 9. |
Remove the key lock cylinder (A).
|
Installation
1.
Install the key lock cylinder.
2.
Install the key warning switch and key Illumination.
3.
Install the key wa ...
See also:
Rear Package Tray Trim Component Location
(4Door)
1. Rear package tray trim
(2Door)
1. Rear package tray trim
...
Using the usb device
To use an external USB device, make sure the device is not connected when
starting up the vehicle. Connect the device after starting up.
If you start the engine when the USB device is connected ...
Output Speed Sensor Removal
1.
Disconnect the negative (-) battery cable.
2.
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - &qu ...
Copyright © www.kifomanual.com 2014-2025