|
1. |
Installation is in reverse order of removal.
|
2. |
Perform bleeding air procedure in concentric slave cylinder after
pouring the brake fluid.
(Refer to Concentric Slave Cylinder Assembly - "Adjustment")
|
On-board Refueling Vapor Recovery (ORVR) valve Removal
1.
Turn the ignition switch OFF, and then remove battery (-) cable.
2.
Remove the fuel pump.
(Refer to Fuel System - "Fuel Pump&qu ...
Transaxle Oil Temperature Sensor Installation
1.
Install in the reverse order of removal.
After replacement or reinstal ...
Rear Torsion Beam Axle Replacement
1.
Loosen the wheel nuts slightly. Raise the vehicle, and make sure
it is securely supported.
2.
Remove the front wheel and tire (A) from f ...