Kia Forte: Purge Control Solenoid Valve (PCSV) Inspection - Engine Control System - Engine Control / Fuel System - Kia Forte TD 2014-2018 Service ManualKia Forte: Purge Control Solenoid Valve (PCSV) Inspection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Purge Control Solenoid Valve (PCSV) Inspection

1.
Turn the ignition switch OFF.
2.
Disconnect the PCSV connector.
3.
Measure resistance between the PCSV terminals 1 and 2.
4.
Check that the resistance is within the specification.

Specification: Refer to “Specification”

Purge Control Solenoid Valve (PCSV) Circuit Diagram
(M/T) (A/T) ...

Purge Control Solenoid Valve (PCSV) Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the purge control solenoid valve connector (A) ...

See also:

Auto Defogging Sensor Replacement
1. Disconnect the negative (-) battery terminal. 2. Disconnect the sensor cover (A) and then remove the auto defogging sensor (B). ...

Using the usb device
To use an external USB device, make sure the device is not connected when starting up the vehicle. Connect the device after starting up. If you start the engine when the USB device is connected ...

Manifold Absolute Pressure Sensor (MAPS) Description
Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and is installed on the surge tank. It senses absolute pressure of the surge tank and transfers the analog signal propo ...

Copyright © www.kifomanual.com 2014-2025