Kia Forte: Starter Removal - Starting System - Engine Electrical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Starter Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Electrical System / Starting System / Starter Removal

1.
Disconnect the battery negative terminal.
2.
Remove the air duct and air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
3.
Disconnect the starter cable (A) from the B terminal on the solenoid then disconnect the connector from the S terminal (B).

4.
Remove the 2 bolts holding the starter, then remove the starter (A).

Starter Circuit Diagram
...

Starter Installation
1. Install in the reverse order of removal. Starter installation bolt: 49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft) ...

See also:

Rear Torsion Beam Axle Inspection
1. Check the hub for cracks and the splines for wear. 2. Check the rear axle carrier for cracks. ...

Power Mosfet Replacement
1. Disconnect the negative (-) battery terminal. 2. Disconnect the power mosfet connector (A) and then remove the power mosfet (B) after lo ...

Water pump Inspection
1. Check each part for cracks, damage or wear, and replace the coolant pump assembly if necessary. 2. Check the bearing for damage, abnorm ...

Copyright © www.kifomanual.com 2014-2025