Kia Forte: ISG (Idle Stop & Go) System

Variable Charge Motion Actuator (VCMA) Installation

   • Install the component with the specified torques. • ...

Description

Idle Stop & Go (ISG) function automatically switches off the engine when the car is at a standstill if the and starts it again as soon as the brake pedal is released. This not only reduce ...

See also:

Crankshaft Position Sensor (CKPS) Installation
   • Install the component with the specified torques. • ...

Mode Control Actuator Description
The mode control actuator is located at the heater unit. It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing ...

Rear Torsion Beam Axle Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from f ...